Syncterm raspberry pi software#
The MSS100 is not a software modem emulator.
Syncterm raspberry pi serial#
Like a modem, that behavior is configured using AT commands from that serial device. The MSS100 also emulates a modem from the perspective that if it receives a network socket connection, it can output the appropriate result codes to the serially attached device. It can even be another MSS100 operating in its normal mode or modem emulation mode. Being an IP based device, it would be some sort of host with an IP address and a listening port. A serial device server, like the MSS100, also has to have something to connect to. What happens on the other side of the connection is up to you.Ī real modem has to have something to connect to. But rather than dialing a phone number and going over a POTS phone line, it goes over an IP connection. What you have to understand is that modem emulation means that a serially attached device will think it is connected to a modem. It does exactly what it states it does, allow a serial device to use AT commands to initiate a connection to an IP host and, in receiving an IP connection, provide the appropriate result codes for the serial device an answer an incoming IP connection. There is no requirement for proprietary software to use it in the place of a modem. The MSS100 does emulate a modem on its own.
In other words, it can't be used (as i thought it Could be) to run any kind of bbs software (DOS,Amiga, Commodore, Atari)īelow is the email I received from lantronix after wasteing an hour of my time on tech support: Interface without useing their specialized com port redirection software, found HERE: It can be a hardware terminal/modem to telnet adapter, but it cant do telnet to a modem The system thats "Dialing in" in order to use it. You can dial out from it with no prolbem, but you need to create a com port redirector on Going on, and estabilish a connection with the telnet program "dialing in" However, i had to switch modes while the terminal programĮssentially, you get one choice or the either. I was able, just once, to type ATA while the "ring" was The terminal screen, but, in doing so, it will not respond to at commands. It can be configured to that "ring" appears on HOWEVER, if you want to actually receive calls via telnet, its useless. You can enter the ip address in where the phone number would normally go It will accept standard AT commands, eg AT ip.address. Essentially, if you want to use the device to telnet to another system, your fine.
0 kommentar(er)
